PARTS AVAILABLE

Our parts for sale are listed as follows. We will be updating the list with parts as we complete them or sell them.

BRAKE CYLINDERS

We supply new Westinghouse 8 x10” brake cylinders for smaller cars, (12-ton like car 183 here at Ridgewood or a Birney’s car) In the range of 28’-33’ length.

Universal brake cylinder, ABU Type 8.5 x 12”. Westinghouse Wabteck #667058.
Universal brake cylinder, ABU Type 8.5 x 12”. Westinghouse Wabteck #667058.

Because this is a universal brake cylinder for small cars, it requires a supply line adapter. Please contact us for 1/2 threaded adapter flange and O-ring. Weight 62 lbs. Westinghouse tech drawing available.-

Complete Resistance Grid Set
Complete Resistance Grid Set

We have 1 interurban control resistance grid bank in stock. It is in excellent physical condition. No broken grids. It can be tested in our shop. At 700 vdc. With a light load and a resistor. Each box should average between 1 and 3 OHMs. These are heavy grids not like #1, 2, and 3. Designed for control of a 4-motor car at 125 HP per motor.

We would advise a plywood case on a pallet to protect the grids from potential damage.

Price $1250.00

12 Circuit breaker out of box

Railway locomotives have increasingly high amperage circuit breakers in the range of hundreds of amps.  The old Westinghouse and General Electric line breakers for trolley cars seldom exceeded even on large equipment, 200 amps.  For protection of the motormen overhead magnetic line breakers could usually be tuned from 40 to 75 amps.  Why?  Substations for transit operations usually had 2000 or more amps available to the transit system.  A K controller in a short circuit (line voltage to ground) could and sometimes did explode.  A sensitive line breaker saved many a car an injury of operator.

We still service line breakers, MR12, MR22 and other industrial line breakers and we will recalibrate the spring amperage disconnect. 

1880 Passenger Car Back
1880 Passenger Seat Back 18″ high x 20″ wide, hardwood.

Bench seat back from the 1898 from an open car. It is of hardwood construction. Make an offer.

Headlight bezel and mounting ring for early Brill Tam.
Headlight bezel and mounting ring for early Brill Tram.

Single headlight bezel, O’Porto from car #268.
Price $275.00

Springboard support castings for Brill 21E Truck.
Springboard support castings for Brill 21E Truck.

Brill 21E Spring Plank Bracket. 1 left and 1 right. These are patterns, we have them in stock. They run about $80 a piece.

Safety Rail Latch for open car seating.
Safety Rail Latch for open car seating.

Safety rail latches (new) for open cross bench seating. In stock, new for sale.
Price $62.00

Brass Flag Holder
Brass Flag Holder

New polished Brass Flag holders are in stock, packaged, and ready to ship. Used on sides and end of trams for ID and special movements / runs.

Price $171.00

Sander Hose Brackets
Brill single tram truck sander hose braces (used) 4 only, for sale. Last used on an Australian Brill. Make an offer.
 

2 Hand operated door levers–Mechanical only. Last arch roof St. Louis car company double truck with mechanical only door openers.  $30 each or $50 for both


S16C Westinghouse Air Governor. Pressure range 60-160 psi. Operating range 85-100 psi.  Seems to be complete. May need gaskets. Comes with cover. Price $800.
(Core value $500 and general appearance $300.)

Westinghouse Type J. Normally found on interurban cars up to about 1920. 

Description: 1 used complete Type J air governor for DH-12 and DH-16 type air compressors. 1 without a cover may be ok, but we would suggest it for spare parts.

Price: $640.00 for both.